2410 Oil in Water Analyzer
The Waltron 2410 Oil-in-Water Analyzer is a state-of-the-art instrumentation package developed specifically to measure the amount of hydrocarbons in clean water. The 2410 has many uses and will fit a large variety of online water analyzer applications.
The 2410 utilizes optical sensors to measure absorbed and scattered light in a sample stream. The measurement distinguishes between oil droplets and turbidity. A microprocessor calculates the ppm oil concentration based on the sensor signal. The analyzer measures the concentration of oil continuously and activates alarms and relays as necessary. Applications include: boiler condensate returns, process cooling water, process steam monitoring and wastewater.
Compact design
Calibrates directly to clean water
Wide range analysis: 1 – 99 ppm
Automatic and continuous self diagnostics
Turbidity compensation
Rapid Response
Minimal maintenance required
Automatic operation
PERFORMANCE
Range
0 – 99 ppm
Accuracy
∓ 2 ppm
Calibration
Calibrates directly to clean water
Current Outputs
0 – 20mA, 4-20mA (800Ω min. load); 0-5VDC, 1 – 5VDC (50KΩ min. load)
Alarms
Two adjustable operating delay alarms (0 – 60 sec, 10 – 240 sec); contacting rating 8A @ 240V
Power
230/115VAC or 24VAC, 50/60Hz; consumption 10VA max
CE Certification (on request)
Meets low voltage and low electromagnetic compatibility directives
Electrical Installation
EN61010-1EC664 category 11
OPERATING CONDITIONS
Sample Flow
0.26 – 0.53 gal/min (0.1 – 2.0 L/min)
Sample Temperature
34 – 104° F (1 – 40°C)
Ambient Temperature
34 – 140°F (1 – 60°C)
Pressure
1.45 – 145 psig (0.1 – 10 bar)
Humidity
90% RH Max @ 131°F (55°C)
MECHANICAL
Construction
Meets IP55
Dimensions
Height=8.5” (215mm); Width=9.5” (242mm); Depth=2.9” (73mm)
Weight
4.96 lbs (2.25 kg)
Finish
Corrosion resistant
There are no reviews yet.